Grand Caravan V6-3.8L VIN L (2007)
Camshaft Position Sensor: Service and Repair
Removal - 3.3/3.8L
REMOVAL - 3.3/3.8L
1. Disconnect the negative battery cable.
2. Remove the air box cover and inlet tube (Figure 1).
Figure 1 AIR BOX COVER
3. Disconnect camshaft position sensor electrical connector from the wiring harness connector (Figure 2).
Figure 2 CAMSHAFT POSITION SENSOR
4. Remove bolt holding sensor.
5. Rotate sensor away from block.
6. Pull sensor up out of the chain case cover. Do not pull on the sensor wiring. There is an O-ring on the body of the sensor. The O-ring may make
removal difficult. A light tap to top of sensor prior to removal may reduce force needed for removal.
