Grand Caravan V6-3.8L VIN L (2007)
Seat Occupant Classification Module - Air Bag: Service and Repair
Installation
INSTALLATION
WARNING: To avoid personal injury or death, on vehicles equipped with the Occupant Classification System (OCS), only the Occupant
Classification Module (OCM) may be serviced separately. All other components of the passenger front seat cushion must be serviced only as a
complete factory-calibrated, assembled and tamper-evident service replacement package.
Once any of the original factory-installed components except the OCM have been replaced with the service replacement package components, the OCM
can only be serviced by replacing the entire passenger side front seat cushion unit with another complete service replacement package.
WARNING: On vehicles equipped with the Occupant Classification System (OCS), never replace both the Occupant Restraint Controller
(ORC) and the Occupant Classification Module (OCM) at the same time. If both require replacement, replace the OCM first. Then perform
the Airbag System test including an ignition-On time of at least one minute before replacing the ORC. Both the ORC and the OCM store OCS
calibration data, which they transfer to one another during the first minute of ignition-On time after one of them is replaced. If both modules
are replaced at the same time, an irreversible fault will be set in both modules.
1. Carefully position the Occupant Classification Module (OCM) to the OCM bracket (Figure 1). When the OCM is correctly positioned, the
connector on the module will be pointed to right side of the vehicle.
2. Install the two screws to the OCM. Torque the screws to 2 Nm (20 in.lbs.).
3. Connect the seat wire harness connector for the OCM. Be certain that the latches on the connector are each fully engaged.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
WARNING: Following successful completion of the Airbag System test procedure, the Occupant Classification System Verification Test
must be done using a scan tool and the appropriate diagnostic information.
4. Verify vehicle and system operation.
5. Close hood.
Figure 1 OCM - REMOVE/INSTALL
