Grand Caravan V6-3.8L VIN L (2007)
6. Install the front door sill plate (Figure 2).
7. Install the lower seat belt anchor bolt (Figure 1). Torque bolt to 39 Nm (29 ft.lbs.).
NOTE: If equipped with the Occupant Classification System (OCS), there is a Belt Tension Sensor located on the lower seat belt anchor on the
passenger front seat belt.
8. Connect the belt tension sensor connector (if equipped with OCS) (Figure 1).
9. Install the upper B-pillar trim cover (Figure 2).
10. Install the bolt attaching turning loop to shoulder belt height adjuster (Figure 2). Torque bolt to 39 Nm (29 ft.lbs.).
11. Install the cover to the seat belt turning loop (Figure 2).
12. Install the shoulder harness height adjuster knob by pushing it straight onto the adjuster (Figure 2).
13. Move seat back to approximate customer position.
WARNING: If equipped with the OCS, do not connect the battery negative cable. Personal injury or death may result if the system test is
not performed first.
WARNING: If equipped with the OCS, following successful completion of the Airbag System test procedure, the Occupant Classification
System Verification Test must be done using a scan tool and the appropriate diagnostic information.
14. Verify vehicle and system operation.
15. Close hood.
Figure 1 BELT TENSION SENSOR/LOWER SEAT BELT ANCHOR
