Grand Caravan V6-3.8L VIN L (2007)
Impact Sensor: Service and Repair
Installation
INSTALLATION
FRONT IMPACT SENSOR
1. Position sensor in vehicle (Figure 3).
2. Install the two retaining screws to the impact sensor (Figure 3). Torque screws to 7 Nm (62 in.lbs.).
3. Connect electrical connector (Figure 3).
4. Lower vehicle from hoist.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
5. Verify vehicle and system operation.
6. Close hood.
SIDE IMPACT SENSORS
B-PILLAR MOUNTED
1. Position sensor bracket in vehicle (Figure 4).
2. Install the four retaining screws to the impact sensor bracket (Figure 4). Torque screws to 7 Nm (62 in.lbs.).
3. Connect the electrical connector (Figure 4).
4. Install the B-pillar lower trim for the side of the vehicle that you are replacing the side impact sensor.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
5. Verify vehicle and system operation.
6. Close hood.
SLIDING DOOR OPENING MOUNTED
7. Connect electrical connector (Figure 2).
8. Position sensor in vehicle (Figure 2).
9. Install the two retaining screws to the impact sensor (Figure 2). Torque screws to 7 Nm (62 in.lbs.).
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
10. Verify vehicle and system operation.
11. Close hood.
QUARTER PANEL MOUNTED
12. Position sensor in vehicle (Figure 1).
13. Connect electrical connector (Figure 1).
14. Install the two retaining screws to the impact sensor (Figure 1). Torque screws to 7 Nm (62 in.lbs.).
15. Install the quarter trim panel for the side of the vehicle that you are replacing the side impact sensor.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
