Grand Caravan V6-3.8L VIN L (2007)
CAUTION: After slotting the strut clevis bracket hole, do not install the original attaching bolts when assembling the steering knuckle to
the strut assembly. Only the flange bolts, cam bolts, and dog bone washers from the service package must be used to attach the steering
knuckle to the strut after the mounting hole is slotted.
NOTE: The strut clevis-to-knuckle bolts are installed differently on each side of the vehicle. Left-hand-side bolts are installed from
vehicle rear to front (Figure 3). Right-hand-side bolts are installed from vehicle front to rear.
5. Position the knuckle back into the strut clevis bracket. Using the direction indicated in the above note, install a flanged bolt from the service
package into the upper mounting hole. Using the direction indicated in the above note, install a cam bolt into the bottom mounting hole (Figure 3).
Figure 3 Package Bolts Correctly Installed
6. Install a dog bone washer on the steering knuckle to strut clevis bracket attaching bolts, then install the nuts onto the bolts from the service
package (Figure 4). Tighten the bolts just enough to hold the steering knuckle in position when adjusting camber, while still allowing the steering
knuckle to move in clevis bracket.
