Grand Caravan V6-3.8L VIN L (2007)
Installation
PUMP - 3.3L/3.8L
1. Install power steering pump back in vehicle using the reverse order of its removal through the engine compartment of the vehicle.
2. Install the power steering pump on its mounting bracket.
3. Install the 3 front power steering pump mounting bolts (Figure 2). Tighten the 3 front power steering pump mounting bolts to a torque of 54 Nm
(40 ft. lbs.).
NOTE: Before installing power steering pressure hose on power steering pump, inspect the O-ring on the power steering pressure hose
for damage and replace if required.
4. Install the power steering fluid pressure line into the pressure output fitting of the power steering pump (Figure 1). Do not fully tighten tube nut
at this time.
5. Install the power steering fluid supply hose on the power steering pump supply fitting (Figure 1). Be sure hose clamp is properly installed.
6. Raise the vehicle.
7. Install the routing clip on the engine for the pressure hose (Figure 3) and tighten fastener.
8. Install the serpentine drive belt.
9. Install the drive belt splash shield.
10. Lower the vehicle.
11. Tighten the pressure line to pump pressure fitting tube nut to a torque of 31 Nm (275 in. lbs.).
12. Install the wiper module (unit).
13. Connect the negative battery cable on the negative battery post.
14. Fill and bleed power steering system.
15. Inspect for leaks.
Figure 1 SUPPLY AND PRESSURE HOSES AT PUMP
