Grand Caravan V6-3.8L VIN L (2007)
Figure 6 Clutch Pedal Interlock Switch
1 - CLUTCH INTERLOCK SWITCH
2 - CLUTCH PEDAL/BRACKET ASSY.
Installation
INSTALLATION
LHD
1. Install interlock switch into pedal bracket hole, and secure harness with retainer (Figure 3). Make sure switch wing tabs are fully expanded.
2. Connect interlock switch connector.
3. Install knee bolster (Figure 1).
4. Install instrument panel lower silencer (Figure 4).
5. Connect battery negative cable.
6. Verify function of starter interlock switch. Switch must actuate when pedal is depressed.
RHD
1. Install interlock switch to pedal bracket assembly as shown in (Figure 3). Secure connector with retainer to hole in bracket.
2. Install clutch pedal bracket assembly into position. Install pedal bracket mounting nuts and torque to 28 Nm (250 in. lbs.).
3. Connect interlock and upstop switch connectors.
4. Install clutch master cylinder into position and rotate 45° counter-clockwise to secure to pedal bracket (Figure 2). Secure dash panel grommet and
secure hydraulic pluming into dash panel retainers.
5. Connect master cylinder pushrod to clutch pedal pin and secure with retainer clip (Figure 2).
6. Install knee bolster (Figure 1).
7. Install instrument panel lower silencer (Figure 4).
8. Connect battery negative cable.
9. Verify function of starter interlock switch. Switch must actuate when pedal is depressed.
Figure 1 KNEE BOLSTER, LHD SHOWN
1 - KNEE BOLSTER
