Grand Caravan V6-3.8L VIN L (2007)
Windshield Washer Pump: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Hoist and support vehicle on hoist or jack stands.
3. If necessary, remove the right front wheel and tire assembly.
4. Disconnect the right front wheelhouse splash shield and move aside.
5. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the
front (outboard) washer pump port and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front
washer pump port.
6. Disconnect the electrical body harness connectors to the washer pump motor. Slide the red lock on the connector to the release position, then,
depress the black tab and pull the connector off the pump.
7. Remove pump from reservoir by pulling pump upper retention tab away from reservoir cavity and then lifting pump up from mounting grommet.
Do not damage reservoir/pump sealing surface or puncture reservoir during removal.
8. Remove pump grommet and discard.
