dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Body - Rear Bumper Fascia Bulge/Bow or Bend|Page 9867 > < Body - Rear Bumper Fascia Bulge/Bow or Bend|Page 9865
Page 2
background image

1.

Open the liftgate.

2.

Inspect the scuff pad on the top of the rear fascia. Is scuff pad lifting off fascia?

a.

Yes >>> Using a Trim Stick C-4755, remove scuff pad and discard. Scuff pad will be replaced later in this procedure. Proceed to Step # 3.

b.

No >>> Proceed to Step # 3.

3.

Loosen 4 rear fascia retaining screws (Fig 1)

4.

Hold the fascia at the proper level to obtain proper fascia top edge mating lines at tail light and snug upper bolts only.

5.

Use a protected wooden or plastic handle to apply outward pressure in lower corners of fascia liftgate opening to reduce bow in top of fascia and
tighten lower screw on both sides with fascia in new position (Fig 2).

6.

Tighten the 4 screws to 5.5 N.m (49 in.lbs).

Body - Rear Bumper Fascia Bulge/Bow or Bend|Page 9867 > < Body - Rear Bumper Fascia Bulge/Bow or Bend|Page 9865