Grand Caravan V6-4.0L (2008)
a.
Yes >>> Proceed to Step # 9.
b.
No >>> Proceed to Step # 10.
8.
Replace and refinish rear fascia per manufacturers instructions. Refer to the detailed removal procedures available in DealerCONNECT >
TechCONNECT under: Service Info > 13 - Frame And Bumpers > Rear Fascia > Removal.
NOTE:
When installing the new fascia, pull the fascia outboard by applying pressure at outside corners to reduce bow in top of fascia.
9.
Was scuff pad removed from fascia for lifting off fascia in or for fascia replacement?
a.
Yes >>> Proceed to Step # 10.
b.
No >>> Proceed to Step # 14.
10.
Clean the fascia and underside of the new scuff pad where the strip of tape will be applied. The strip of tape should be located between the forward
row of carrots and the forward edge of the scuff pad (Fig. 3).
11.
Wipe cleaned fascia and scuff pad surface with adhesion promoter and allow to dry.
12.
Apply a 925 mm (36.4 in.) strip of tape to underside of scuff pad.
13.
Install scuff pad to fascia starting at the center and working to the ends. Press firmly along taped area to ensure wetout.
14.
Drill a 6.35 mm (.25 in.) hole thru fascia and plastic fascia support 15 mm forward of scuff pad at centerline of fascia.
15.
Install push pin p/n 06501916 into hole.
POLICY:
Reimbursable within the provisions of the warranty.
