Grand Caravan V6-4.0L (2008)
1. Using the supplied plastic tie strap, secure both harnesses together as shown in Figure 9. The power sliding door wiring harness must be routed to the
rear (in car position) of the drive motor wiring harness.
CAUTION:
Do not over tighten the tie strap. Over tightening the tie strap may cut through the convolute or tape.
2. Cut off the tail of the tie strap and rotate the tie strap so that the tie strap lock is tucked under the wiring harnesses.
3. Install the partially removed sliding door weather seal. Be sure to tuck the wiring harness behind the weather seal inner retaining lip.
4. Move the sliding door manually and verify that the lower hinge does not contact the weather seal and/or any portion of the wiring harnesses.