Grand Caravan V6-4.0L (2008)
7. Disengage the two lower "B" post wiring harness retainers from the retention holes (Figure 14).
8. Remove the wiring harness retainer from the front of the black plastic split tube of the power sliding door wiring harness, noting its original location
(Figure 14).
9. Carefully unwrap the power sliding door wiring harness starting at the front end (in car position) of the black plastic split tube (Figure 14). Unwrap
enough of the cloth tape to expose the chaffed wires.
10. Select the appropriate wire splice band package based on the wire gauge of the chaffed wire. The power sliding door harness has nine 16-gauge
wires. The drive motor harness has two 20-gauge wires and two 12-gauge wires.
11. Using diagonal cutters, cut through the damaged wire in the middle of the chaffed area (Figure 15).
12. Remove approximately one-half (1/2) inch (13 mm) of insulation from both wires using wire strippers.
