Grand Caravan V6-4.0L (2008)
After the first RKE transmitter has been programmed, follow the screen prompts to program the second RKE transmitter.
j.
Select "Finish" after the second FOBIK has been programmed.
k.
Select "Show Shortcuts".
l.
Select "Home" to return to the "Home" screen.
6.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the RKE transmitter programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle,
if so equipped. Some DTC's may cause the MIL to illuminate.
a.
From the "Home" screen select "System View".
b.
Select "All DTCs".
c.
Select "Clear All Stored DTCs" if there are any DTCs shown on the list.
d.
Select "Yes" to clear all stored DTC's.
7.
Turn the ignition key to the "OFF" position. Remove the StarSCAN unit, StarSCAN cable, and battery charger from the vehicle.
8.
Verify that both RKE transmitters start the vehicle and that the transmitter functions properly.
9.
Close the hood.
10.
The original RKE transmitters must be destroyed and scrapped. Do not return the original transmitters to the customer.
B.
Reprogram the RKE Transmitter Using StarMOBILE
1.
Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during
the flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand alone voltmeter. The battery charger volt meter may not be sufficiently accurate. Voltages outside of the specified range will
cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor
to lower the voltage.
2.
Connect the StarMOBILE scan tool to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN"
position.
3.
Power ON the StarMOBILE scan tool.
4.
Connect the CH9410 StarMOBILE scan tool ethernet cable to the StarMOBILE and the dealer's network drop.
5.
From the desktop, launch the "StarMOBILE Desktop Client" software.
6.
Establish a connection with the StarMOBILE scan tool.
7.
Select "ECU View".
8.
Select "WCM Wireless Control".
9.
Select "MISC. Functions".
10.
Highlight "Program Ignition Keys or Key FOBs" and select "Start".
11.
Select "Next".
12.
Enter the Personal Identification Number (PIN) for that vehicle.
NOTE:
The PIN number can be obtained from the original selling invoice, DealerCONNECT > Parts > Key Codes, or contacting the District Manager.
