Grand Caravan V6-4.0L (2008)
Install wheel speed sensor grommet (2) into flex hose bracket (1) on frame rail.
6. Clip wheel speed sensor connector and routing clip (3) to bracket (2) on frame rail.
7. Connect vehicle wiring harness (1) to wheel speed sensor connector.
8. Install brake shield on knuckle. Install and tighten three mounting screws to 8 Nm (71 in. lbs.).
9. Install brake rotor as well as all components necessary to access it.See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation
10. Verify that wheel speed sensor cable is properly routed and not coming into contact with rotor or other moving parts.
11. Perform the Diagnostic Verification Test and clear any faults.See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests
