Grand Caravan V6-4.0L (2008)
6. If equipped with adjustable pedals:
a. Disconnect the wiring connector (1) at the stop lamp switch (2).
b. Rotate the stop lamp switch clockwise until the retaining tabs line up with the slot in the bracket (3), then remove and discard the switch (1).
Do not reuse switch; install NEW switch upon Installation. See: Lighting and Horns/Brake Light Switch/Service and Repair/Removal
7. If equipped with non-adjustable pedals:
a. Disconnect the wiring connector (1) at the stop lamp switch (3).
b. Rotate the stop lamp switch clockwise until the retaining tabs line up with the slot in the bracket (2), then remove and discard the switch (3).
Do not reuse switch; install NEW switch upon Installation. See: Lighting and Horns/Brake Light Switch/Service and Repair/Removal
8. Remove booster push rod (2) from pin (3) on brake pedal. To do so:
a. Position small screwdriver between center tang on power brake booster brake pedal pin retaining clip (1).
b. Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin, then slide retaining clip off brake pedal pin.
c. Discard retaining clip. It is not to be reused. Install NEW retaining clip when assembling.
d. Slide booster push rod (2) off brake pedal pin (3).
