dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C Line - Removal|Page 8128 > < A/C Line - Removal|Page 8126
Page 1
background image

Hose/Line HVAC: Service and Repair
A/C Line - Installation

Discharge Line

INSTALLATION

CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system See: Service and
Repair/Procedures/Refrigerant Oil Level. Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as
designed and can cause serious A/C compressor damage.

NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be
added to the refrigerant system See: Service and Repair/Procedures/Refrigerant Oil Level.

NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace
the rubber O-ring seals and metal gaskets may result in a refrigerant system leak.

NOTE: 4.0L engine shown. Other engines similar.

1. Position the A/C discharge line (1) into the engine compartment.
2. Remove the tape or plugs from the opened refrigerant line fittings and the compressor and condenser ports.
3. Lubricate new rubber O-ring seals with clean refrigerant oil and install them and new gaskets onto the discharge line fittings. Use only the

specified O-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.

4. Connect the A/C discharge line to the A/C compressor (3).
5. Install the nut (2) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 23 Nm (17 ft. lbs.).

6. Connect the A/C discharge line (1) to the condenser tapping block (2).
7. Install the nut (3) that secures the A/C discharge to the A/C condenser. Tighten the nut to 23 Nm (17 ft. lbs.).
8. Connect the negative battery cable.
9. Evacuate the refrigerant systemSee: Service and Repair/Procedures/Refrigerant System Evacuate.

10. Adjust the refrigerant oil levelSee: Service and Repair/Procedures/Refrigerant Oil Level.
11. Charge the refrigerant systemSee: Service and Repair/Procedures/Refrigerant System Charge.

Liquid Line

INSTALLATION

A/C Line - Removal|Page 8128 > < A/C Line - Removal|Page 8126