Grand Caravan V6-4.0L (2008)
Engine Control Module: Service and Repair
Engine Control Module (ECM)
Removal
REMOVAL
NOTE: The Engine Control Module (ECM) is located on the left side of the engine compartment.
1. Disconnect and isolate negative battery cable.
2. Disconnect the harness connector (2) from the ECM (3).
3. Remove the two bolts (1) and remove the ECM (3) from the bracket (4).
Installation
INSTALLATION
1. Install the ECM (3) and bolts (1) to bracket (4). Tighten the bolts to 4.5 Nm (40 in. lbs.).
2. Connect the harness connector (2) to the ECM (3).
3. Connect negative battery cable.
4. Using scan tool, program the all necessary information into the ECM,See: Testing and Inspection/Engine Control Module (ECM).
