Grand Caravan V6-4.0L (2008)
3. Select "ECU View".
4. Select "WCM/WIN".
5. Select "Miscellaneous Functions".
6. Select WCM/WIN replaced.
7. Enter the PIN when prompted.
8. Verify the correct information.
NOTE: If the PCM/ECM and the SKIM are replaced at the same time, all vehicle keys will need to be replaced and programmed to the
new WIN.
PROGRAMMING IGNITION KEYS TO THE WIN
Each FOBIK has a unique ID code that is assigned at the time the key is manufactured. When a key is programmed into the WIN, the transponder ID
code is learned by the module and the transponder acquires the unique Secret Key ID code from the WIN. To program ignition keys into the WIN,
follow the programming steps outlined in the diagnostic scan tool for PROGRAM IGNITION KEYS OR KEY FOBS under MISCELLANEOUS
FUNCTIONS for the WIRELESS IGNITION NODE/WIN menu item.
NOTE: If the original keys do not successfully program to the new WIN after the proper procedures are followed correctly, programming new
keys will be necessary.
NOTE: A maximum of eight keys can be learned to each WIN. Once a key is learned to a WIN, that key has acquired the Secret Key for that
WIN and cannot be transferred to any other WIN or vehicle.
If FOBIK programming is unsuccessful, the scan tool will display one of the following error messages:
-
PROGRAMMING NOT ATTEMPTED - The scan tool attempts to read the programmed key status and there are no keys programmed into
WIN memory.
-
PROGRAMMING KEY FAILED (POSSIBLE USED KEY FROM WRONG VEHICLE) - WIN is unable to program an FOBIK
transponder due to one of the following:
-
The FOBIK transponder is ineffective.
-
The ignition FOBIK is or has been already programmed to another vehicle.
-
8 KEYS ALREADY LEARNED, PROGRAMMING NOT DONE - The SKREEM transponder ID memory is full.
-
LEARNED KEY IN IGNITION - The ID for the FOBIK that is currently in the WIN cylinder is already programmed into WIN memory.
