Grand Caravan V6-4.0L (2008)
Once the leg(s) are unlatched the seat will push upwards to allow the obstruction to be removed.
NOTE:
The leg latch must be held in the open position until the seat can be pushed upward. If the latch is not held open, it will re-latch preventing upward
movement.
4.
After the obstruction is removed, push the Third Row Power Seat "Normal switch button located in the "D pillar. This will cause the seat to cycle
to the latched position and the seat will now work normally.
5.
**Continue with the Flash Repair Procedure**.
SPECIAL TOOLS/EQUIPMENT REQUIRED:
FLASH REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
NOTE:
Before performing this Repair Procedure, the operating software in the StarSCAN(R); must be programmed with software release level 8.03 or
higher. The software release level is visible in the blue header at the top of the StarSCAN(R) screen.
NOTE:
The StarSCAN® diagnostic scan tool fully supports Internet connectivity. However, to take advantage of this feature you must first configure the
StarSCAN® for your dealership's network. Make sure the StarSCAN® is configured to the dealership's network before proceeding. For instruction
on setting up your StarSCAN(R) for the dealer's network refer to either:
"DealerCONNECT > Service> StarSCAN and StarMOBILE tools > Online Documentation", or refer to the StarSCAN(R) Quick Start Networking
Guide. The StarSCAN(R) Quick Start Networking Guide is also available on the website under the "Download Center".
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1.
Install a battery charger and verify that the charging rate provides approximately 13.5 volts. Set the battery charger to continuous charge. Do not
allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is complete.
2.
Connect the CH9410 StarSCAN(R) ethernet cable to the StarSCAN(R) and the dealer's network drop.
3.
Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle data link connector (DLC).
4.
Power ON the StarSCAN®.
5.
Select "ECU View"
6.
Touch the screen to highlight FSM in the list of modules.
7.
Select "More Options"
8.
Select "ECU Flash".
9.
Record the "Part Number", displayed on the "Flash Fold and Stow" screen, for later reference.
10.
Select "Browse for New File~. Follow the on screen instructions.
11.
Highlight the listed Fold and Stow calibration.
