Grand Caravan V6-4.0L (2008)
Power Distribution Module: Service and Repair
Module-Totally Integrated Power Module
Removal
REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.
3. Release the Totally Integrated Power Module (TIPM) cover retaining clips and open the TIPM cover.
4. Remove the TIPM positive cable retaining nut and remove the cable from the stud.
5. Depress the four mounting clips to disengage and remove the TIPM housing from its mounting bracket.
6. Disconnect the wire harness connectors.
7. Remove the TIPM from the vehicle.
Installation
INSTALLATION
CAUTION: The original Cab Compartment Node (CCN) and Powertrain Control Module (PCM) must be installed and functioning properly
prior to powering up the new Totally Integrated Power Module (TIPM). The TIPM receives vehicle configuration data from the CCN and
Vehicle Identification Number information from the PCM. If configuration information becomes lost or corrupted, the data can be obtained
from DealerCONNECT
1. Position the TIPM into the engine compartment.
2. Connect the electrical wire harness connectors.
3. Position the TIPM positive cable onto the mounting stud and install the retaining nut. Tighten the nut to 9 - 11 Nm (80 - 100 in. lbs.).
4. Position the TIPM onto the mounting bracket and push down until the mounting clips are fully seated.
5. Open the TIPM cover and fully seat the Airbag fuse holder (two fuses in one yellow carrier) and the Ignition Off Draw (IOD) fuse.
6. Connect the battery negative cable.
7. Close the hood.
8. Insert the ignition key and turn it to the "RUN" position and wait twelve seconds. The TIPM will collect the necessary vehicle configuration and
VIN data from the CCN and PCM at this time. After twelve seconds turn the ignition key to the "OFF" position and then back to the "ON"
position and verify proper vehicle systems operation.
