Grand Caravan V6-4.0L (2008)
Integrated Accessory Switch Assembly: Service and Repair
Instrument Panel Switch Pod - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position the instrument panel switch pod (2) to the back of the instrument panel center bezel (1).
2. Install and tighten the two screws (3) that secure the switch pod to the center bezel. Tighten the screws securely.
3. Reconnect the wire harness connector to the back of the switch pod.
4. Reinstall the center bezel onto the instrument panel.See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel - Installation.
5. Reconnect the battery negative cable.