Grand Caravan V6-4.0L (2008)
Power Seat Switch: Service and Repair
Power Seat Switch - Installation
Front Seat
INSTALLATION
1. Position the power seat switch (2) onto the seat cushion side shield (3). Gently apply pressure to the switch until the four mounting tabs (1) are
fully seated into place.
2. Connect the power seat switch electrical connector (4).
3. Install the seat cushion side shield,See: Body and Frame/Seats/Seat Cushion/Service and Repair/Seat Cushion Side Shields - Installation.
4. Connect the battery negative cable.
5. Verify normal operation of the power seat assembly.
Third Row - D-Pillar Switch
INSTALLATION
1. Position the third row power folding seat switch (4) into the left rear of vehicle.
2. Connect the switch electrical connector (3).
3. Push switch into upper D-Pillar trim panel (5) until retaining tabs are fully engaged.
4. Connect the battery negative cable.
5. Using an appropriate scan tool, check and erase any third row power folding seat control module diagnostic trouble codes related to the D-Pillar
switch.
Third Row - Leg Latch Actuator Position Switch
INSTALLATION
