Grand Caravan V6-4.0L (2008)
1. Position the switch (1) onto the seat leg assembly (3). Ensure the alignment stud is in the hole on the leg assembly and that the rivet hole is aligned.
2. Install the retaining rivet (2).
3. Install the tie strap holding the switch wire harness and leg latch release cable (5) to the seat leg assembly.
4. Connect the switch electrical connector (1).
5. Install the seat cushion and cover assembly,See: Body and Frame/Seats/Seat Cushion/Service and Repair/Seat Cushion / Cover - Installation.
6. Install the third row power folding seat,See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Seat - Installation.
7. Perform the third row power folding seat recliner calibration,See: Body and Frame/Seats/Service and Repair/Procedures/Third Row Power
Folding Seat Recliner Calibration. Verify proper seat operation.
Third Row Seat Recliner Switch
INSTALLATION
NOTE: The procedure for replacing the seat recliner switch is the same for both the 60 and 40 third row power folding seats. The following
steps should be performed only on the seat with the inoperative seat recliner switch.
1. Insert the switch (3) into the switch retaining cover (2).
2. Install the switch and retaining cover assembly into the seat cover.
a. Slide the switch and retaining cover assembly (2 & 3) into the two holding tabs (4) of the switch retainer sewn into the seat cover (1).
