Grand Caravan V6-4.0L (2008)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor - Installation
INSTALLATION
1. Apply bearing grease (supplied with part) to sensor head shaft and O-ring.
CAUTION: Ensure that sensor mounting surface on bearing is clean before sensor installation.
2. Push wheel speed sensor head (1) into mounting hole in hub and bearing (3) and align mounting screw hole.
3. Install NEW mounting screw (2). Tighten mounting screw to 6 Nm (55 in. lbs.).
4. Install wheel speed sensor routing clip (2) into hole in rear axle.
5. Install wheel speed sensor (3) into routing clips (1) along brake flex hose.
6. Install wheel speed sensor (1) into routing clips along underbody of vehicle.
7. Connect vehicle wiring harness (2) to wheel speed sensor connector.
8. Right side sensor only - Install exhaust heat shield above exhaust system covering wheel speed sensor wiring connector.
9. Install brake rotor as well as all components necessary to access it.See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Brake Rotor - Installation
10. Perform the Diagnostic Verification Test and clear any faults.See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests