Grand Caravan AWD V6-229 3.8L VIN L MFI (1997)
Be careful not to allow the pin to fall out of the assembly during installation. If the pin falls out of the assembly for any reason, make sure that the pin
is clean and undamaged before reinstalling.
17.
Insert the new piston assembly into the cylinder bore, seal end first (Figure 8). Ensure that the pin remains centered in the piston.
Caution:
Do not insert a screwdriver or other sharp objects into the end of the primary piston. This may damage the booster rod contact surface.
18.
With the piston installation tool still in place over the piston, slide the new snap-ring in place over the installation tool.
Caution:
Make sure that the piston installation tool is tight against the piston guide and does not allow the snap-ring or snap-ring pliers to contact the primary
piston during assembly.
19.
Grasp the snap-ring with snap-ring pliers, then press on the end of the installation tool until the guide seats in the cylinder bore and the snap-ring
groove is visible.
20.
While depressing the piston with the installation tool, install the snap-ring into the snap-ring groove.
21.
Verify that the snap-ring is properly installed in its groove by depressing and releasing the installation tool several times. Visually check to make
sure the snap-ring is properly seated.
22.
Install the provided vacuum seal into the master cylinder flange groove (Figure 9). Make sure that the seal is fully inserted and sits squarely in the
