Grand Caravan AWD V6-229 3.8L VIN L MFI (1997)
Rear Speed Sensor Routing Brackets And Clips
5. Remove the rear wheel speed sensor cable/brake tube routing clips. Then un-clip the speed sensor cable from the routing clips on rear brake tube.
CAUTION: If the speed sensor has seized due to corrosion, do not use pliers on speed sensor head in a attempt to remove it. Use a hammer and a
punch and tap edge of sensor, rocking the sensor from side to side until free.
Speed Sensor Attaching Bolt
6. Remove the wheel speed sensor attaching bolt. If sensor head does not come loose, do not use pliers on the sensor head to loosen. Tap sensor head
from side to side to loosen.
7. Remove the wheel speed sensor from the rear bearing assembly.
8. Remove the speed sensor assembly from the vehicle.
Installation
PROCEDURE
CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers.
Failure to install cables in retainers as in this section may result in contact with moving parts and/or over extension of cables, resulting in an open
circuit.
1. Install wheel speed sensor head. Note, the plastic anti rotation pin must be fully seated prior to installing the attaching bolt.
CAUTION: Prior to installing the speed sensor head attaching bolt, the plastic anti-rotation pin must be fully seated into the bearing flange.
