Grand Caravan AWD V6-3.8L VIN L (2001)
Trunk / Liftgate Shock / Support: Service and Repair
SUPPORT CYLINDER
REMOVAL
1. Release liftgate latch and open liftgate.
2. Support liftgate on a suitable lifting device in the full open position.
3. Pull liftgate opening weatherstrip from D-pillar flange next to prop assembly end pivot.
Fig. 5
4. Remove bolt attaching end pivot to D-pillar (Fig. 5).
5. Remove bolt attaching prop assembly to liftgate.
6. Remove prop assembly from vehicle.
INSTALLATION
Ensure that the cylinder end is attached to the D-pillar and the shaft end is attached to the liftgate.
1. Place prop assembly in position.
2. Install bolt attaching prop assembly to liftgate.
3. Install bolt attaching end pivot to D-pillar. Tighten bolts to 34 N.m (25 ft.lbs.) torque.
4. Install liftgate opening weatherstrip to D-pillar flange next to prop assembly end pivot.
5. Close liftgate. Check liftgate operation.
