Grand Caravan AWD V6-3.8L VIN L (2001)
2. Completely retract the caliper piston back into the bore of the caliper.
CAUTION: Use care when installing the caliper onto the disc brake adapter to avoid damaging the boots on the caliper guide pins.
3. Install the disc brake caliper over the brake shoes on the brake caliper adapter.
4. Align the caliper guide pin bolt holes with the guide pins. Install the caliper guide pin bolts and tighten them to a torque of 35 Nm (26 ft. lbs.).
5. Install the tire and wheel assembly. Tighten the wheel mounting nuts to a torque of 135 Nm (100 ft. lbs.).
6. Lower the vehicle.
7. Pump the brake pedal several times. This will set the shoes to the brake rotor.
8. Check and adjust the brake fluid level as necessary.
9. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoes.
Rear
REMOVAL - REAR DISC BRAKE SHOES
1. Raise vehicle on jackstands or centered on a hoist.
2. Remove rear wheel and tire assemblies from vehicle.
3. Remove the caliper to adapter guide pin bolts.
4. Remove rear caliper from adapter using the following procedure. First rotate rear of caliper up from the adapter. Then pull the front of the caliper
