Grand Caravan AWD V6-3.8L VIN L (2001)
Ambient Temperature Sensor / Switch HVAC: Testing and Inspection
Ambient Temperature Sensor Circuit Test
1. Turn the ignition switch to the OFF position. Disconnect and isolate the battery negative cable. Disconnect the ambient temperature sensor wire
harness connector and the Front Control Module wire harness connector.
2. Connect a jumper wire between the two terminals in the body half of the ambient temperature sensor wire harness connector.
3. Check for continuity between the sensor return circuit and the ambient temperature sensor signal circuit cavities of the Front Control Module wire
harness connector. There should be continuity. If OK, go to Step 4. If not OK, repair the open sensor return circuit or ambient temperature sensor
signal circuit to the ambient temperature sensor as required.
4. Remove the jumper wire from the body half of the ambient temperature sensor wire harness connector. Check for continuity between the sensor
return circuit cavity of the Front Control Module wire harness connector and a good ground. There should be no continuity. If OK, go to Step 5.If
not OK, repair the shorted sensor return circuit as required.
5. Check for continuity between the ambient temperature sensor signal circuit cavity of the Front Control Module wire harness connector and a good
ground. There should be no continuity. If OK, refer to Diagnosis and Testing - Overhead Console. If not OK, repair the shorted ambient
temperature sensor signal circuit as required.
