Grand Caravan AWD V6-3.8L VIN L (2001)
Blower Motor: Service and Repair
Rear Blower Motor
REMOVAL
NOTE: The rear blower motor and blower wheel are serviced only as a balanced unit. If either component is faulty or damaged, the entire unit must be
replaced.
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation.
1. Remove the rear heater-A/C unit housing from the vehicle. Refer to
2. Disconnect the rear blower motor pigtail wire connector. With manual temperature control, the blower pigtail wire is connected to a take out and
connector of the rear HVAC wire harness. With automatic temperature control, the blower pigtail wire is connected to a receptacle on the blower
power module.
Fig.5 Blower Motor
3. Remove the three screws that secure the blower motor to the outboard side of the rear heater- A/C unit housing.
4. Remove the blower motor and blower wheel from the rear heater-A/C unit housing.
INSTALLATION
1. Position the blower motor and blower wheel onto the outboard side of the rear heater-A/C unit housing.
2. Install and tighten the three screws that secure the blower motor to the rear heater-A/C unit housing. Tighten the screws to 2 Nm (18 in. lbs.).
3. Reconnect the rear blower motor pigtail wire connector. With manual temperature control, the blower pigtail wire is connected to a take out and
connector of the rear HVAC wire harness. With automatic temperature control, the blower pigtail wire is connected to a receptacle on the blower
power module.