Grand Caravan AWD V6-3.8L VIN L (2001)
3. Install a new filter and O-ring on bottom of the valve body (Fig. 216).
4. Clean the oil pan and magnet. Reinstall pan using new Mopar Silicone Adhesive sealant. Tighten oil pan bolts to 19 Nm (165 inch lbs.).
5. Pour four quarts of Mopar ATF +4 (Automatic Transmission Fluid) Type 9602 through the dipstick opening.
6. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
7. Check the transaxle fluid level and add an appropriate amount to bring the transaxle fluid level to 3 mm (1/8 inch) below the lowest mark on the
dipstick (Fig. 217).
8. Recheck the fluid level after the transaxle has reached normal operating temperature (180°F.).
9. To prevent dirt from entering transaxle, make certain that dipstick is fully seated into the dipstick opening.
DIPSTICK TUBE FLUID SUCTION METHOD (ALTERNATIVE)
1. When performing the fluid suction method, make sure the transaxle is at full operating temperature.
2. To perform the dipstick tube fluid suction method, use a suitable fluid suction device (macular or equivalent).
3. Insert the fluid suction line into the dipstick tube.
NOTE: Verify the the suction line is inserted to the lowest point of the transaxle oil pan. This will ensure complete evacuation of the fluid in the
pan.
4. Follow the manufacturers recommended procedure and evacuate the fluid from the transaxle.
5. Remove the suction line from the dipstick tube.
6. Pour four quarts of Mopar ATF +4 (Automatic Transmission Fluid) Type 9602 through the dipstick opening.
7. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
8. Check the transaxle fluid level and add an appropriate amount to bring the transaxle fluid level to 3 mm (1/8 inch) below the lowest mark on the
dipstick (Fig. 217).
9. Recheck the fluid level after the transaxle has reached normal operating temperature (180°F.).
