Grand Caravan AWD V6-3.8L VIN L (2001)
NOTE: Before installing power steering pressure hose on power steering pump, inspect the O-ring on the power steering pressure hose for damage
and replace if required.
4. Install the power steering fluid pressure line into the pressure output fitting of the power steering pump. Tighten the pressure line to pump fitting
tube nut to a torque of 31 Nm (275 inch lbs.).
5. Install the power steering fluid low-pressure return hose on the power steering pump low pressure fitting. Be sure hose clamps are properly
reinstalled.
6. Raise the vehicle.
7. Install the routing clip on the engine for the pressure hose.
8. Tighten the pump thru-bolt. Tighten to 54 Nm (40 ft. lbs.) torque.
9. Install the serpentine drive belt.
10. Install the drive belt splash shield.
11. Lower the vehicle.
12. Install the wiper module (unit).
13. Connect the negative battery cable on the negative battery post.
14. Fill and bleed the power steering system using the Power Steering Pump Initial Operation Procedure.
See: Initial Operation
15. Inspect for leaks.
