Grand Caravan AWD V6-3.8L VIN L (2001)
11. Install Strut Nut Socket (on the end of a torque wrench), Special Tool 6864, on the strut shaft retaining nut. Next, install a 10 mm socket on the
hex on the end of the strut shaft. While holding the strut shaft from turning, tighten the strut shaft retaining nut to a torque of 100 Nm (75 ft. lbs.).
NOTE: Before releasing the tension the compressor has on the spring, using the figure as reference, make sure the upper spring seat, coil spring and
strut clevis bracket are all lined up properly (within 5° of one another).
12. Slowly release the tension from the coil spring by backing off the compressor drive fully. As the tension is relieved, make sure the upper mount,
pivot bearing and upper seat are align properly. Remove the clamp from the lower end of the coil spring and strut. Push back the spring
compressor upper and lower hooks, then remove the strut assembly from the spring compressor.
13. Install strut assembly on the vehicle.
