Grand Caravan AWD V6-3.8L VIN L (2001)
1. Raise vehicle on a hoist. Place a drain container with a large opening, under transaxle oil pan.
2. Loosen pan bolts and tap the pan at one corner to break it loose allowing fluid to drain, then remove the oil pan.
3. Remove oil filter-to-valve body screws (Fig. 166).
4. Remove oil filter and gasket (Fig. 167).
5. Install a new filter and gasket (Fig. 167).
6. Clean the oil pan and magnet. Reinstall pan using new Mopar Silicone Rubber Adhesive Sealant. Torque oil pan bolts to 19 Nm (165 inch lbs.).
7. Pour four quarts of Mopar ATF +4 (Automatic Transmission Fluid-Type 9602) through the dipstick opening.
8. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
