Grand Caravan FWD L4-2.4L VIN B (1997)
9. Remove speed sensor assembly from vehicle.
Installation
PROCEDURE
CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers.
Failure to install cables in retainers as in this section may result in contact with moving parts and/or over extension of cables, resulting in an open
circuit.
1. Install wheel speed sensor head. Note, the plastic anti rotation pin must be fully seated prior to installing the attaching bolt.
CAUTION: Prior to installing the speed sense head attaching bolt, the plastic anti-rotation pi must be fully seated into the bearing flange.
Rear Wheel Speed Sensor Attaching Bolt
2. Install the wheel speed sensor head to bearing flange attaching bolt. Tighten the attaching bolt to a torque 12 Nm (105 inch lbs.).
3. Check the air gap between the face of the wheel speed sensor and the top surface of the tone wheel. Air gap must be less then the maximum
allowable tolerance of 1.2 mm (.047 inch).
Rear Speed Sensor Routing Brackets And Clips
4. Install the 2 routing brackets attaching the speed sensor cable and brake tube to the rear axle. The rear wheel speed sensor cable should be routed
under the rear brake tube.
CAUTION: When installing rear wheel speed sensor cable in the routing clips on rear brake flex hose, be sure not to damage the routing clips
Routing clips are molded onto the hose and will require replacement of the brake flex hose if damaged during installation of the wheel speed
sensor cable.
5. Install speed sensor cable into routing clips on rear brake flex hose.
