Grand Caravan FWD L4-2.4L VIN B (1997)
CAUTION: A replacement ball joint is not prelubricated. Properly lubricate the replacement ball joint using Mopar Multi-Mile grease or an
equivalent. Lubricate ball joint after seal boot is installed but prior to top of seal boot being pushed down below notch in ball joint stud. Air must
vent out of the seal boot at notch when grease is pumped into ball joint, failure to do so will balloon and damage seal boot. Do not over grease the
ball joint, this will prevent the seal boot from pushing down on the stud of the ball joint.
CAUTION: After the ball joint is properly greased, clip the end of the grease fitting off below the hex. The ball joint seal boot is non-purgeable
and further greasing is not required and can result in damage to the seal boot.
