Grand Caravan FWD L4-2.4L VIN B (1997)
using clevis bracket.
2. Install the spring isolator on the strut lower spring seat. When installing the spring isolator, be sure the 2 retaining tabs on the spring isolator are
installed in the 2 holes in the spring seat. When properly installed, the oversize holes in the spring seat should line up with the holes in the spring
isolator.
WARNING: If a replacement coil spring is to be installed on the strut assembly, the first full top and bottom coil of the spring must be
captured by the jaws of the coil spring compressor.
3. Install the jounce bumper on the shaft of the strut assembly. Jounce bumper is to be installed with the small end of the jounce bumper pointing
down.
4. Install the dust shield on the strut assembly. After dust shield is installed on strut, collapse dust shield down on top of jounce bumper until jounce
bumper snaps into dust shield. Then return the dust shield to its fully extended length.
