Grand Caravan FWD V6-3.0L VIN 3 (1999)
20.
If the seatback is not being replaced, flip the seatback cover up, so that the cover is inside out and 3/4 of the seatback cushion foam is exposed
(Figure 8).
CAUTION:
Use extreme care when removing the seat cover from the seatback foam. The hook and loop strip that holds the seat cover to the seatback foam
trench could rip loose from the foam before the fasteners separates (Figure 8). Wedge a plastic trim stick between the two sides of the hook
and loop strips to disengage the strips. Pulling on one side of the strip without holding the other side will pull the strip off the foam before the
two pieces separate. Should the hook and loop fastener separate from the foam, use P/N 04773774 adhesive or equivalent to bond the strip
onto the seat foam.
21.
Cut off and discard all the old wires that are attached to the inside of the seatback cover (Figure 8). Make the cuts as close as possible to the cover
surface.
