Grand Caravan FWD V6-3.0L VIN 3 (1999)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings
or seals, damage may result. If assembly of component is difficult, use water to aid assembly. Use care when removing hoses to prevent damage to hose
or hose nipple.
REMOVAL
1. Disconnect negative cable from battery.
2. Remove electrical connector from idle air control motor.
Servicing Idle Air Control Motor
3. Remove idle air control motor mounting screws.
4. Remove motor from throttle body. Ensure the O-ring is removed with the motor.
INSTALLATION
1. The new idle air control motor has a new O-ring installed on it. If pintle measures more than 1 inch (25 mm) it must be retracted. Use the DRB
Idle Air Control Motor Open/Close Test to retract the pintle (battery must be connected.)
2. Carefully place idle air control motor into throttle body.
3. Install mounting screws. Tighten screws to 2 Nm (17 in. lbs.) torque.
4. Connect electrical connector to idle air control motor.
5. Connect negative cable to battery.
