Grand Caravan FWD V6-3.0L VIN 3 (1999)
TRANSMISSION FLUID TEMPERATURE CHART
8. Recheck the fluid level after the transaxle has reached normal operating temperature (180°F).
9. To prevent dirt from entering transaxle, make certain that dipstick is fully seated into the dipstick opening
ALTERNATIVE SERVICE METHODS (FLUID ONLY)
TRANSAXLE FLUID EXCHANGER METHOD
CAUTION The use of any fluid exchanger that introduces additives into the transaxle is not recommended.
1. To perform the transaxle fluid exchange, the transaxle must be at operating temperature. Drive the vehicle until it reaches full operating
temperature.
2. Obtain a suitable transaxle fluid exchanger and verify the tank is clean and dry.
3. Fill the tank to the recommended fill capacity with Mopar ATF+4 Type 9602.
4. Connect the machine to the vehicle following the manufacturers instructions. Perform the exchange procedure following the instructions provided
with the machine.
5. Once machine has completed the fluid exchange. Check the fluid level and condition and fill to proper level with Mopar ATF+4 Type 9602. Refer
to Fluid Level and Condition Check for the proper fluid "top-off" procedure.
NOTE: Verify that the transaxle cooler lines are tightened to proper specifications. Cooler line torque specification is 2 Nm (18 inch lbs.).
DIPSTICK TUBE FLUID SUCTION METHOD
1. When performing the fluid suction method, make sure the transaxle is at full operating temperature.
2. To perform the dipstick tube fluid suction method, use a suitable fluid suction device (macular or equivalent).
3. Insert the fluid suction line into the dipstick tube.
NOTE: Verify that the suction line is inserted to the lowest point of the transaxle oil pan. This will ensure complete evacuation of the fluid in the
pan.
4. Follow the manufacturers recommended procedure and evacuate the fluid from the transaxle.
5. Remove the suction line from the dipstick tube.
6. Pour four quarts of Mopar ATF+4 (Automatic Transmission Fluid) Type 9602 through the dipstick opening.
7. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
8. Check the transaxle fluid level and add an appropriate amount to bring the transaxle fluid level to 3 mm (1/8 inch) below the "ADD" mark on the
dipstick.
9. Recheck the fluid level after the transaxle has reached normal operating temperature (180°F.).
