Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
12. Remove latch/lock from door.
INSTALLATION
1. Position latch/lock locking lever in unlocked position.
2. If equipped, engage wire connector into power door lock motor (Fig. 4).
3. Place latch/lock in position on door (Fig. 5).
CAUTION: REPLACE BOLTS IF INSTALLING NEW LATCH.
4. Insert bolt into slots in sliding door inner panel.
5. Tighten bolts attaching latch/lock assembly to sliding door.
6. Engage inside cable into latch/lock assembly.
7. Install inside door handle assembly.
8. Install foam block.
9. Engage external cable to latch/lock assembly.
10. Engage link rod to bellcrank.
11. Engage hold open latch cable from lower hinge.
12. Engage clip to hold bellcrank link to latch/lock control.
13. Verify sliding door operation.
14. Install latch/lock cover.
15. Insure that enough adhesive remains to securely retain the watershield. Replace as necessary.
16. Place the watershield into position and press securely to adhesive making sure to properly route wiring and linkages.
17. Install sliding door stop bumper.
18. Install sliding door trim panel.
