Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
1. Place carpet through sliding door opening into position.
2. Roll carpet rearward towards the rear door opening.
3. Roll carpet forward under instrument panel (Fig. 8).
4. Install push pins fasteners through carpet and grommet into floor to attach carpet to floor in front seat area.
5. Pull wire harnesses through the carpet as needed.
6. Smooth out the carpet and allowing weld studs to go all the way through the carpet.
7. Install rear push pins fasteners attaching rear of carpet.
8. Place third row carpet cover into position and press clips into position (Fig. 9).
9. Slide the carpet under the quarter trim panel into position.
10. Install lower B-pillar trim covers.
11. Install sliding door sill plates.
12. Install front carpet trim ring and cover (Fig. 7).
13. Install seat belt anchors at the passenger side B-pillar and driver side C-pillars
14. Install kick plate and heel pad at the gas pedal
15. Install winch plug (spare tire winch) (Fig. 6).
16. Install front cowl panels and sill plates.
17. Install heel blocker (plastic block below accelerator pedal).
18. Install the floor console base tray and disconnect wire connector from the base tray.
19. Install instrument panel lower console.
20. Install front seats.
21. Install floor mats.
