Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
1. Remove rear header trim cover.
2. Remove liftgate sill plate.
3. Remove second row seat belt turning loop on long wheel base vehicle.
4. Remove bolt attaching second row seat belt, anchor to quarter on short wheel base vehicle.
5. Disengage hidden clips attaching trim to D-pillar.
6. Remove D-pillar trim panel from D-pillar.
7. Disconnect speaker wire connector, if equipped.
8. Pass second row seat belt, if equipped, through slot in trim panel on short wheel base vehicle.
9. Remove D-pillar trim from vehicle.
INSTALLATION
1. Position D-pillar trim on vehicle.
2. Pass second row seat belt, if equipped, through slot in trim panel on short wheel base vehicle.
3. Connect speaker wire connector to speaker, if equipped.
4. Align locating pins on backside of trim panel to mating holes in D-pillar.
5. Engage hidden clips attaching trim to D-pillar.
6. Install screws attaching trim panel to attaching bracket on short wheel base vehicle.
7. Install quarter trim bolster on short wheel base vehicle.
8. Install bolt to attach second row seat belt, if equipped, anchor to quarter on short wheel base vehicle. Tighten all seat belt bolts to 39 N.m (29
ft.lbs.) torque.
9. Install second row seat belt turning loop on long wheel base vehicle.
10. Install liftgate sill plate.
11. Install rear header trim cover.
Left Quarter Trim Panel
LEFT QUARTER TRIM PANEL
REMOVAL
CAUTION: Disconnect the negative cable clamp from battery post. Damage to accessory feed circuit can result.
1. Remove first row seat.
2. Remove second row seat, if equipped.
3. Remove front door sill plate on three door vehicle.
4. Remove sliding door sill plate on four door vehicle.
5. Remove left quarter trim bolster.
6. Remove C-pillar trim panel.
7. Remove left D-pillar trim panel.
8. Remove first row seat belt anchor.
9. Remove second row seat belt anchor on long wheel base vehicle.
10. Remove screws attaching quarter trim to quarter panel from bolster area.
11. Remove screws attaching rear edge of quarter trim to attaching bracket or inner quarter trim panel.
12. Disconnect wire connector from accessory power outlet, if equipped.
13. Remove quarter trim from quarter panel.
14. Pass front seat belt and turning loop through slot in quarter trim panel on three door vehicle.
15. Pass first row seat belt through slot in quarter trim panel.
16. Pass second row seat belt, if equipped, through slot in quarter trim panel on long wheel base vehicle.
17. Remove quarter trim panel from vehicle.
INSTALLATION
1. Position quarter trim panel on vehicle.
2. Pass second row seat belt, if equipped, through slot in quarter trim panel on long wheel base vehicle.
3. Pass first row seat belt through slot in quarter trim panel.
4. Connect wire connector into accessory power outlet, if equipped.
5. Align locating pins on backside of trim panel to mating holes in inner panels.
6. Position quarter trim panel on inner quarter panel.
7. Install screws attaching rear edge of quarter trim to attaching bracket or inner quarter panel.
8. Install screws attaching quarter trim to inner quarter panel in bolster area.
9. Install second row seat belts anchor on long wheel base vehicle. Tighten all seat belt bolts to 39 N.m (29 in.lbs.) torque.
10. Install first row seat belt anchor.
11. Install left D-pillar trim panel.
12. Install C-pillar trim panel.
13. Install upper left B-pillar trim on three door vehicle.
