dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Driver Power Seat Track Replacement|Page 9356 > < Driver Power Seat Track Test|Page 9353
Page 1
background image

Seat Track: Service and Repair
Driver Power Seat Track Replacement

REMOVAL

WARNING:  SOME VEHICLES ARE EQUIPPED WITH SEATBACK MOUNTED AIRBAGS. BEFORE ATTEMPTING TO DIAGNOSE
OR SERVICE ANY SEAT OR POWER SEAT SYSTEM COMPONENT YOU MUST FIRST DISCONNECT AND ISOLATE THE
BATTERY NEGATIVE CABLE. THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE
FURTHER SYSTEM SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO DO SO COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Remove the appropriate seat from the vehicle and place it on a clean work surface.
2. Remove the Body Control Module retaining screws.
3. Disconnect the body control module electrical connectors and remove the body control module from the power seat track.
4. Remove the rear fabric blocker trim panel from the rear of the front seat.
5. Remove the seat side cover and power seat switch as an assembly.
6. Disconnect all electrical connectors connecting the power seat track to the seat assembly
7. Pull the seat back trim cover up slightly to access and remove the two seat back frame mounting bolts and also remove two seat back recliner bolts.
8. Remove four seat track mounting bolts from the seat cushion pan.
9. Remove the power seat track from the seat.

INSTALLATION

1. Position the seat cushion on the seat track.
2. Install the four seat track retaining bolts in the seat cushion pan. Torque the bolts to 28.5 Nm.
3. Position the seat back and install the two seat back frame mounting bolts and the two seat back recliner bolts. Torque the bolts to 55 Nm.
4. Route and connect the electrical connectors between the power seat track and the seat assembly
5. Install the seat side cover and power seat switch as an assembly.
6. Install the rear fabric blocker trim panel on the rear of the front seat.
7. Position the body control module and connect the body control module electrical connectors.
8. Install the Body Control Module retaining screws
9. Install the seat assembly in the vehicle.

Driver Power Seat Track Replacement|Page 9356 > < Driver Power Seat Track Test|Page 9353