Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Power Seat Switch: Service and Repair
Passenger Seat Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.4 Removing Switch Control Knobs
2. On models equipped with the eight-way power seat, using a push pin remover or another suitable wide flat-bladed tool, gently pry the power seat
and power recliner switch knobs off of the switch levers.
3. Remove the screws that secure the outboard seat cushion side shield to the seat cushion frame. Refer to the Body section of the service manual for
the procedure.
4. Pull the outboard seat cushion side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
5. Disconnect the power seat wire harness connector from the power seat switch connector receptacle.
6. Remove the screws that secure the power seat switch to the inside of the outboard seat cushion side shield.
7. Remove the power seat switch from the outboard seat cushion side shield.
INSTALLATION
1. Position the power seat switch onto the outboard seat cushion side shield.
2. Install and tighten the screws that secure the power seat switch to the inside of the outboard seat cushion side shield. Tighten the screws to 1.5 Nm
(14 in. lbs.).
3. Reconnect the power seat wire harness connector to the power seat switch connector receptacle.
4. Position the outboard seat cushion side shield onto the seat cushion frame
5. Install and tighten the screws that secure the outboard seat cushion side shield to the seat cushion frame. Tighten the screws to 1.5 Nm (14 in. lbs.)
.
6. Install the switch knobs on the switch control levers, if equipped.
7. Reconnect the battery negative cable.
