Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
8.
Install the pistons and boots to the wheel cylinder. Make sure that the boots seal properly onto the casting groove all the way around the wheel
cylinder. With your fingers, shuttle pistons back and forth in the wheel cylinder bore to distribute lubricant. Do not allow the boots to become
dislodged from wheel cylinder casting groove.
9.
Insure the wheel cylinder is sealed to the backing plate. If not, seal around the perimeter of the wheel cylinder using a small bead of RTV (p/n
05010884M).
10.
Install the brake shoes using the procedures outlined in the appropriate Town & Country, Caravan and Voyager Service Manual.
NOTE:
INSURE BOTH (2) INSPECTION AND ADJUSTMENT PLUGS (p/n 04238721) ARE PRESENT IN THE BACKING PLATE
11.
Wipe any spilled fluid from the outside of the wheel cylinder, as well as any other brake parts, including the linings.
12.
Repeat step 2 through 10 for other brake assembly.
13.
Install the brake drums and rear tire/wheel assemblies. Torque the lug nuts to 135 Nm (100 ft.lbs.).
14.
Lower the vehicle.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
