Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Wheel Speed Sensor: Technical Service Bulletins
Brakes - Rear Wheel Speed Sensor Replacement Guidelines
NUMBER: 05-004-04 REV. A
GROUP: Brakes
DATE: December 3, 2004
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 05-004-04, DATED SEPTEMBER 2, 2004, WHICH SHOULD BE
REMOVED FROM YOUR FILES. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE ADDITIONAL MODELS.
SUBJECT:
Anti-lock Brake Rear Wheel Speed Sensor Replacement
MODELS:
**2001 - 2005
(RG)
Chrysler Voyager**
2001 - 2005
(RS)
Town & Country/Caravan/Voyager
NOTE:
This bulletin applies to non-all wheel drive vehicles equipped with anti-lock brakes (sales code BGF).
PARTS REQUIRED:
DISCUSSION:
When replacing a rear wheel speed sensor, upon disassembly, inspect for moisture on the sensor and inside the bearing cap. If moisture is present, the
moisture must be dried out prior to reassembly, or the new sensor may be damaged.
When installing a replacement wheel speed sensor, be sure to lubricate the sensor 0-ring and the sensor head completely, with Mopar wheel bearing
grease, p/n 05083149AA, before installation.
NOTE:
It is important that only Mopar, p/n 05083149AA, Wheel Bearing Grease, or M56560 equivalent, be used for this application. No other lubricant
may be substituted. Other lubricants may cause sensor damage.
POLICY:
Information Only.
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
