Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
15.
Remove the upper half of the recirculation air door from the lower half of the door (Fig. 4).
16.
Remove the twelve screws around the perimeter of the evaporator housing that secure the upper housing half to the lower half.
17.
Carefully separate and remove the upper half of the evaporator housing from the lower half. Be certain not to loose the rubber grommet for the
HVAC wire harness evaporator temperature sensor take out. This grommet is located on the inboard side of the flange around the expansion valve
/evaporator tube opening on the dash panel side of the unit, where it is captured in a notched area between the upper and lower housing halves
(Fig. 5).
18.
With the evaporator assembly removed from the evaporator housing, install the rubber evaporator tube insert (p/n 05061454AA) between the
evaporator inlet and outlet tubes as shown (Fig. 5).
Assemble the HVAC housing as follows:
