Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Receiver Dryer: Service and Repair
REMOVAL
WARNING: REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE
FOLLOWING OPERATION.
1. Recover the refrigerant from the refrigerant system.
2. Remove the air cleaner housing from the right side of the engine compartment.
Fig.32 Front Liquid Lines
3. Remove the screw that secures the liquid line front section fitting to the top of the filter-drier.
4. Disconnect the liquid line fitting from the filter-drier inlet port.
5. Remove the seal from the liquid line fitting and discard.
6. Install plugs in, or tape over the opened liquid line fitting and the filter-drier inlet port.
7. Remove the screw that secures the liquid line rear section fitting to the top of the filter-drier.
8. Disconnect the liquid line fitting from the filter-drier outlet port.
9. Remove the seal from the liquid line fitting and discard.
10. Install plugs in, or tape over the opened liquid line fitting and the filter-drier outlet port.
11. Remove the two nuts that secure the filter-drier mounting bracket to the weld studs on the side of the right front strut tower.
12. Remove the filter-drier and mounting bracket unit from the studs.
INSTALLATION
NOTE: If the filter-drier is being replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant oil of
the type recommended for the compressor in the vehicle.
1. Position the filter-drier and mounting bracket unit onto the weld studs on the side of the right front strut tower.
2. Install and tighten the two nuts that secure the filter-drier mounting bracket to the studs. Tighten the nuts to 10 Nm (89 in. lbs.).
3. Remove the tape or plugs from the liquid line rear section fitting for the filter-drier and the filter-drier outlet port.
4. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting.
