Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Fig.29 Condenser Connections
7. Remove the nut that secures the liquid line fitting to the condenser on the right side of the cooling module.
8. Disconnect the liquid line fitting from the condenser outlet port.
9. Remove the seal from the liquid line fitting and discard.
10. Install plugs in, or tape over the opened liquid line fitting and the condenser outlet port.
Fig.30 Front Liquid Lines
11. Disengage the retainer that secures the liquid line routing clip to the top of the right frame rail ahead of the front strut tower in the engine
compartment.
12. Remove the screw that secures the liquid line front section fitting to the top of the filter-drier.
13. Disconnect the liquid line fitting from the filter-drier inlet port.
14. Remove the seal from the liquid line fitting and discard.
15. Install plugs in, or tape over the opened liquid line fitting and the filter-drier inlet port.
16. Remove the front section of the front liquid line from the engine compartment.
Rear Section
1. Recover the refrigerant from the refrigerant system.
2. Disconnect and isolate the battery negative cable.
3. Remove the air cleaner housing from the right side of the engine compartment.
4. Disconnect the drain tube from the wiper module drain on the right side of the engine compartment.
5. Remove the A/C pressure transducer from the fitting on the front liquid line rear section.
6. Remove the nut that secures the A/C ground strap to the weld stud on the top of the right front strut tower.
7. Remove the A/C ground strap eyelet terminal connector from the weld stud.
8. Remove the screw that secures the liquid line rear section fitting to the top of the filter-drier.
9. Disconnect the liquid line fitting from the filter-drier outlet port.
10. Remove the seal from the liquid line fitting and discard.
11. Install plugs in, or tape over the opened liquid line fitting and the filter-drier outlet port.
12. Remove the nut that secures the suction line and liquid line fittings to the expansion valve.
13. Disconnect the suction line and liquid line fittings from the expansion valve.
